Using linux to create adsl dial-up connection before. We need to see our computer itself has not installed the rpm package pppoe.
If you use the above command does not show rp-pppoe-3.5-32.1 package name. That we need to manually install. If your linux version is more in AS 4. Can be found inside the first CD-ROM package. You can use the command :
rpm-ivh rp-pppoe-3.5-32.1.i386.rpm us to install them.
Installed. Our implementation of the adsl-setup command to enable the configuration wizard. In the following prompts in the wizard. According to the information they need prompt.
The first step to enter the name of our ADSL, where I entered is: adsl_test
The second step we need to configure the ADSL connection card required name: eth1
The third step we need to configure the dial-up type. If the user can set the monthly subscription has been online. To the actual situation according to their need to change their type: No
The fourth step we need to set DNS address, if they know that our DNS addresses. Can enter their own know the address. If you do not know how I can enter "Server", which means the time when the success of our dial-up access to IP addresses automatically from the ISP :
Step into our ADSL Password:
The sixth step we need to choose whether to allow ordinary users to connect and disconnect the ADSL connection, where we choose to NO
Step Seven Select the firewall type, we can customize the firewall rules iptables for more trouble. So we enter "0", do not start the firewall.
Eighth step we need to configure the system boot time whether to activate the ADSL dial-up connection, because it is to debug, I select NO. Do not connect at startup
The ninth step, OK to save the settings, configure the interface will output just our configuration. If configured right, you can enter "y", the Configuration Wizard will automatically generate configuration files